Hi, David--
On Oct 17, 2007, at 4:03 PM, David Yeske wrote:
Is there a way to determine the supported interface speed of a
particular driver? If I have a gigabit ethernet device connected to a
100baseTX switch, how can I determine the interface supports gigabit
ethernet? I have tried parsing the following. Is there a cleaner way
to do this?
Perhaps you want the "ifconfig -m _interface_" command, as in:
# ifconfig -m bge0
bge0: flags=8802<BROADCAST,SIMPLEX,MULTICAST> mtu 1500
options=1a<TXCSUM,VLAN_MTU,VLAN_HWTAGGING>
capability list:
=1a<TXCSUM,VLAN_MTU,VLAN_HWTAGGING>
ether 00:b0:d0:e1:92:a1
media: Ethernet autoselect (none)
status: no carrier
supported media:
media autoselect
media 1000baseTX mediaopt full-duplex
media 1000baseTX
media 100baseTX mediaopt full-duplex
media 100baseTX
media 10baseT/UTP mediaopt full-duplex
media 10baseT/UTP
media none
--
-Chuck
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-stable
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
