Quoting Jeremy Chadwick <[EMAIL PROTECTED]>:
[...]
Set your Cisco configuration to use 100/full, and edit the
ifconfig_bge0 line in rc.conf on your FreeBSD box to have "media
100baseTX mediaopt full-duplex", then reboot the FreeBSD box.
If the problem continues, there may be faulty cabling, but
usually errors on one direction are a sign of duplex mismatch.
If after replacing the cabling the issue continues, then there's
a chance the bge(4) driver may be obtaining statistics wrong for
the particular chip revision being used (this is hearsay on my
part; I'm just guessing...)
Ok, I have set the Cisco port to 100/full-duplex and update the bge*
interfaces on the development server, but the problem still exists.
I have also updated the other server, which is connected to another
Cisco switch, but the same results.
Regards,
Robin
_______________________________________________
freebsd-stable@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-stable
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
