Jamie Clark wrote:
Steven Hartland wrote:
Charles Sprickman wrote:
Backing up the 4.10 box was within an acceptable margin of wire
speed (~8MB/s on 100M ethernet) given that a router was in the
middle. That's roughly how the box has always performed.
After installing 6.1_RELEASE and updating to RELENG_6 I started the
restore. Maxed out at about 380kB/s. Now I tested the backup speed
again and it has also dropepd to 380k.
That speed is indicative of a FD / HD mismatch between the switch
and the NIC if its hard coded try setting auto if its auto try
hardcoding. N.B. Ensure both ends are set in the same way i.e. hard/auto
or problems start.
Both are auto and show 100 FD. The switch port stats show zeros on all
the
error counters.
Good thinking though. I wouldn't yet rule out an external influence as I
have not performed any in-depth diagnosis of this - but I can't think of
anything obvious aside from the OS upgrade.
-Jamie
_______________________________________________
freebsd-stable@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-stable
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
Well my two embedded vr NICs work just fine. I get 8 - 9 MByte / second
with FTP, using vsftpd, and 3-4 Mbyte / sec with SCP. Though this could
also be current CPU issues, as the box is quite busy and the Via C3
isn't all that fast. I am running 6.2-PRERELEASE. Also, did you try
device polling? Maybe that helps, although I currently don't have it in
my kernel configuration.
Here's an ifconfig output, let me know if you need anything else.
[EMAIL PROTECTED] ~> ifconfig
vr0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
inet 10.0.0.1 netmask 0xffffff00 broadcast 10.0.0.255
ether 00:40:63:df:e5:ee
media: Ethernet autoselect (100baseTX <full-duplex>)
status: active
vr1: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
inet 192.168.1.5 netmask 0xffffff00 broadcast 192.168.1.255
ether 00:40:63:df:e5:4e
media: Ethernet autoselect (100baseTX <full-duplex>)
status: active
Cheers,
Jorn
_______________________________________________
freebsd-stable@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-stable
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
