On Fri, 29 Sep 2006 23:05:14 -0700 Sam Leffler <[EMAIL PROTECTED]> wrote:
> Vulpes Velox wrote: > > Any suggestions on this? The card in question one supplied by > > Toshiba in their laptops. > > > > ath0: <Atheros 5424> irq 17 at device 0.0 on pci3 > > ath0: 0x10000 bytes of rid 0x10 res 3 failed (0, 0xffffffff). > > ath0: cannot map register space > > device_attach: ath0 attach returned 6 > > > > > > From lsci -v > > > > 03:00.0 Ethernet controller: Atheros Communications, Inc. Unknown > > device 001c (rev 01) Subsystem: Askey Computer Corp. Unknown > > device 7096 Flags: bus master, fast devsel, latency 0, IRQ 17 > > Memory at <unassigned> (64-bit, non-prefetchable) > > Capabilities: [40] Power Management version 2 > > Capabilities: [50] Message Signalled Interrupts: 64bit- > > Queue=0/0 Enable- Capabilities: [60] Express Legacy Endpoint IRQ 0 > > Capabilities: [90] MSI-X: Enable- Mask- TabSize=1 > > This is likely an ACPI/ASL issue. I saw this on an hp nx6125 laptop > when trying to use the express card slot. The BIOS did not > identify how to map the resources associated with the bridge. Very possibly given some of the funny stuff that shows up in dmesg if I when I poll the processor frequency and temp. Going to check into the ACPI list, iirc there is one, when I get home tomorrow then. Any suggestions on other places to check as well or the like? _______________________________________________ freebsd-stable@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-stable To unsubscribe, send any mail to "[EMAIL PROTECTED]"
