On 10 jul 2006, at 13.59, Johan Ström wrote:
On 10 jul 2006, at 11.09, Johan Ström wrote:
On 21 maj 2006, at 11.16, Johan Ström wrote:
Hi
I've had problems before with GEOM mirror and my SATA drives, and
i've posted about it here before too. The solution seemd to be a
change of motherboard, this reduced the crash very much (and also
the speeds archieved was greatly improved, from 10-15MB/s to
40-50MB/s..).
However after the change i had one or two crashes, but now it has
been running for well over 50-60 days or so without any problems.
Then, 11 days ago I upgraded to 6.1... And now I got these
"crashe"s again (the mirror is crashed that is, the system still
runs fine):
May 21 02:04:58 elfi kernel: ad6: FAILURE - device detached
May 21 02:04:58 elfi kernel: subdisk6: detached
May 21 02:04:58 elfi kernel: ad6: detached
May 21 02:04:58 elfi kernel: GEOM_MIRROR: Device gm0s1: provider
ad6s1 disconnected.
May 21 02:04:58 elfi kernel: g_vfs_done():mirror/gm0s1f[READ
(offset=11006308352, length=2048)]error = 6
May 21 02:04:58 elfi kernel: g_vfs_done():mirror/gm0s1f[READ
(offset=164847927296, length=131072)]error = 6
May 21 02:04:58 elfi kernel: g_vfs_done():mirror/gm0s1f[READ
(offset=256680296448, length=32768)]error = 6
Some info about the controller and disks:
May 9 22:46:52 elfi kernel: ata1: <ATA channel 1> on atapci0
May 9 22:46:52 elfi kernel: atapci1: <nVidia nForce2 Pro SATA150
controller> port
0xec00-0xec07,0xe880-0xe883,0xe800-0xe807,0xe480-0xe483,0x7f00-0x7f0
f,0x7c0
0-0x7c7f irq 22 at device 11.0 on pci0
May 9 22:46:52 elfi kernel: ad4: 286188MB <Maxtor 7L300S0
BANC1G10> at ata2-master SATA150
May 9 22:46:52 elfi kernel: ad6: 286188MB <Maxtor 7L300S0
BANC1G10> at ata3-master SATA150
May 9 22:46:52 elfi kernel: GEOM_MIRROR: Device gm0s1 created
(id=4118114647).
May 9 22:46:52 elfi kernel: GEOM_MIRROR: Device gm0s1: provider
ad4s1 detected.
May 9 22:46:52 elfi kernel: GEOM_MIRROR: Device gm0s1: provider
ad6s1 detected.
May 9 22:46:52 elfi kernel: GEOM_MIRROR: Device gm0s1: provider
ad6s1 activated.
May 9 22:46:52 elfi kernel: GEOM_MIRROR: Device gm0s1: provider
ad4s1 activated.
May 9 22:46:52 elfi kernel: GEOM_MIRROR: Device gm0s1: provider
mirror/gm0s1 launched.
May 9 22:46:52 elfi kernel: Trying to mount root from ufs:/dev/
mirror/gm0s1a
Anyone got any new clues? Afaik the disks should be working fine
(they are 6 months old and this same problem has occured multiple
times...)
Hope to solve this ;)
Thanks
Johan
Here we go again
Jul 7 16:20:09 elfi kernel: ad4: FAILURE - device detached
Jul 7 16:20:09 elfi kernel: subdisk4: detached
Jul 7 16:20:09 elfi kernel: ad4: detached
Jul 7 16:20:09 elfi kernel: GEOM_MIRROR: Device gm0s1: provider
ad4s1 disconnected.
Jul 7 16:20:09 elfi kernel: g_vfs_done():mirror/gm0s1f[READ
(offset=88896847872, length=32768)]error = 6
However no read read timeouts etc as before, just this. 18 days
uptime this time (i've rebooted for other reasons since last
mail). It always seems to be ad4 that is disconnecting.. I'm going
to do some disk tests on it but i doubt it will give anything
since i've had similiar problems from day one (did tests at that
time w/o problems) with this gmirror setup (new disks).
Johan
Followup, I ran over the disk with Maxtors own test program, full
length test. Not a single problem.
After reboot the raid is rebuilding fine:
GEOM_MIRROR: Device gm0s1: rebuilding provider ad4s1.
As usual it seems i cannot get the controller/driver to redetect
the disk using atacontrol etc..
Johan
And now again... raid gone degraded only 2 days after reboot!
Jul 12 22:22:50 elfi kernel: ad4: FAILURE - device detached
Jul 12 22:22:50 elfi kernel: subdisk4: detached
Jul 12 22:22:50 elfi kernel: ad4: detached
Jul 12 22:22:50 elfi kernel: GEOM_MIRROR: Device gm0s1: provider
ad4s1 disconnected.
Jul 12 22:22:50 elfi kernel: g_vfs_done():mirror/gm0s1f[READ
(offset=120776474624, length=32768)]error = 6
$ uname -a
FreeBSD elfi.stromnet.org 6.1-RELEASE FreeBSD 6.1-RELEASE #3: Tue
May 9 20:40:23 CEST 2006 [EMAIL PROTECTED]:/usr/obj/usr/src/
sys/GENERIC i386
Still no luck with atacontrol...
Is there any way to debug this further ?? I've tested the disk, the
SATA cables are new... I've had similar problems with other
motherboard...
I dont think this is related to hw problems, but rather a
softwareproblem that needs to be solved, this is not something one
can call stable ;)
So, any pointers how to enable more debugging or anything that could
give some clues?
Johan
_______________________________________________
freebsd-stable@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-stable
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
