Hi list,
I thought this device was supported:
The nve(4) driver supports the NVIDIA MCP onboard adapters of
mainboards with the following chipsets:
* nForce
* nForce2
* nForce3
* nForce4
Mother board with
NVIDIA® GeForce6100 + nForce 410
from lspci -vv:
00:14.0 Bridge: nVidia Corporation MCP51 Ethernet Controller (rev a1)
Subsystem: Biostar Microtech Int'l Corp Unknown device 2501
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=fast >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 0 (250ns min, 5000ns max)
Interrupt: pin A routed to IRQ 22
Region 0: Memory at fe02d000 (32-bit, non-prefetchable)
Region 1: I/O ports at dc00
Capabilities: [44] Power Management version 2
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA
PME(D0+,D1+,D2+,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
But I don't get a device to ifconfig?
Thanks in advance.
Steve
--
"They that give up essential liberty to obtain temporary safety,
deserve neither liberty nor safety." (Ben Franklin)
"The course of history shows that as a government grows, liberty
decreases." (Thomas Jefferson)
_______________________________________________
freebsd-stable@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-stable
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
