Jason Cox <[EMAIL PROTECTED]> writes: > While trying to get CD burning working under FreeBSD 6.0 (and > 6.1-PreRelease), I keep getting the following error in my dmesg and cd1 > is never created. The drive is a Philips CDRW4012P. It shows up > as /dev/acd1 and reports correctly in dmesg. However, once atapicam > tries to query it, it just repeats the follwoing (output from dmesg with > boot -v): > > ata1: reiniting channel .. > ata1: reset tp1 mask=03 ostat0=50 ostat1=00 > ata1: stat0=0x00 err=0x01 lsb=0x14 msb=0xeb > ata1: stat1=0x00 err=0x01 lsb=0x14 msb=0xeb > ata1: reset tp2 stat0=00 stat1=00 devices=0xc<ATAPI_SLAVE,ATAPI_MASTER> > acd0: setting PIO4 on ICH5 chip > acd0: setting UDMA33 on ICH5 chip > acd1: setting PIO4 on ICH5 chip > acd1: setting UDMA33 on ICH5 chip > ata1: reinit done .. > (probe8:ata1:0:1:0): INQUIRY. CDB: 12 0 0 0 24 0 > (probe8:ata1:0:1:0): CAM Status: SCSI Status Error > (probe8:ata1:0:1:0): SCSI Status: Check Condition > (probe8:ata1:0:1:0): ILLEGAL REQUEST asc:20,0 > (probe8:ata1:0:1:0): Invalid command operation code > (probe8:ata1:0:1:0): (probe8:ata1:0:1:0): INQUIRY. CDB: 12 0 0 0 24 0 > (probe8:ata1:0:1:0): ILLEGAL REQUEST asc:20,0 > (probe8:ata1:0:1:0): Invalid command operation code > Unretryable error > (probe8:ata1:0:1:0): error 22 > (probe8:ata1:0:1:0): Unretryable Error > > I have looked all over the internet and everywhere says it should have > been fixed in 4.7. Any advice on what else to try?
Just the fairly standard stuff; start with a GENERIC kernel and see if you can burn with that. Then load atapicam as a module and see what happens, and whether you can burn with cd1 instead of acd1. > Also, I'm unable to mount any cd from either the Sony DRU-810A (DVD > Burner) or the Philips. What happens when you try? With a GENERIC kernel? _______________________________________________ freebsd-stable@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-stable To unsubscribe, send any mail to "[EMAIL PROTECTED]"
