Wilko Bulte wrote:
On Wed, Feb 08, 2006 at 10:02:08PM +0100, Sren Schmidt wrote..
Wilko Bulte wrote:
Hi Soren,
I just went to 6.1-PRE on my main machine, coming from 6.0-STABLE
of roughly end of december.
And I hit some stuff that really worries me:
- the freshly built kernel keels over with (hand transcribed):
ata3: reiniting channel SATA connect ...
SATA connected
sata_connect_devices 0x1 <ATA_MASTER>
ad6: req=0xC35ba0c8 SETFEATURES SETTRANSFERMODE semaphore timeout
!! DANGER Will RObinson !!
(... is where I cannot read my own handwriting, it scrolled quite fast on
the screen..)
Boot device is a SATA RAID1 on a Promise 2300.
Hmm, that should not happen. Could you try to backstep just ATA to
before the MFC, that is 24/1/06 and let me know if that helps please ?
First impression is that the problem is gone. None of the previously
reported errors are seen. I am running a level 0 dump from disk to disk
to see if the box remains stable. Given that this is my primary machine
I sure hope it will be :-)
Another snag is that my ad10 disk on 6.0-STABLE suddenly became ad12 on
6.1-PRE
Hmm that is because there is only 2 ports on your promise which is now
correctly identified, before it was errounsly found as 3 ports.
Ah, OK. I would suggest a note to the Release Note writers would be a good
thing, devices changing location after an upgrade in the -stable branch
is unnerving ;-)
Well, the good thing is that I can reproduce the error here, the bad
thing is that it slipped through testing on -current...
Oh, well, I'll look into it ASAP...
-Søren
_______________________________________________
freebsd-stable@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-stable
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
