This morning I received a message from my 3ware raid card and I wanted
to know if there is a way to rebuild the raid with out having to reboot
and use the 3ware bios. I know in Linux there is a way to view the
software raid by using the proc. Is there something similar in Freebsd
for hardware or will I have to reboot and use the 3ware bios?
twe0: AEN: <twed0: rebuild done>
twed0: drive timeouttwe0: AEN: <twed0: degraded unit>
BTW, I'm going to replace the problem drive too I just wanted to know if
I can access any of this via the Freebsd.
Thanks for any assistance you offer.
Hardware: 3ware 5800 8 port raid card.
Here's some info from the dmesg:
--------------------------------------------
FreeBSD 4.11-STABLE FreeBSD 4.11-STABLE #0: Thu Dec 8 12:24:06 PST
2005 [EMAIL PROTECTED]:/usr/obj/usr/src/sys/GENERIC i386
twe0: <3ware Storage Controller driver ver. 1.40.01.002> port
0xb400-0xb40f irq 10 at device 11.0 on pci0
twe0: 8 ports, Firmware V4.77 , BIOS V1.02.055
twed0: <Unit 0, TwinStor, Rebuilding> on twe0
twed0: 76318MB (156299440 sectors)
twe0: AEN: <twed0: rebuild done>
twed0: drive timeouttwe0: AEN: <twed0: degraded unit>
_______________________________________________
freebsd-stable@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-stable
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
