On freebsd-stable, [EMAIL PROTECTED] (Jason Harmening) wrote: > Here's the dmesg output from the installer:
> ad4: 70911MB <WDC WD740GD-00FLA1 27.08D27> at ata2-master SATA150 > ad6: 70911MB <WDC WD740GD-00FLC0 33.08F33> at ata3-master SATA150 > ar0: 70911MB <VIA Tech V-RAID RAID0 (stripe 64 KB)> status: READY > ar0: disk0 READY using ad4 at ata2-master > ar0: disk1 READY using ad6 at ata3-master Are you _sure_ that the array is being recognized properly? Based on the dmesg output, it looks like the controller is being read as a 74G drive. FWIW, this is the section of my dmesg output, for a _mirror_: ad4: 78167MB <Maxtor 6Y080P0 YAR41BW0> at ata2-master UDMA133 ad6: 78167MB <Maxtor 6Y080P0 YAR41BW0> at ata3-master UDMA133 ar0: 77247MB <Promise Fasttrak RAID1> status: READY ar0: disk0 READY (master) using ad4 at ata2-master ar0: disk1 READY (mirror) using ad6 at ata3-master > On 12/7/05, Jason Harmening <[EMAIL PROTECTED]> wrote: > > I'm trying to install FreeBSD 6.0-RELEASE on a RAID0 array attached to the > > VIA 8237 controller on my Asus A8V Deluxe motherboard. The array consists > > of two 74G drives. The installer recognizes the array as ar0, but when I > > enter FDISK to set up my partition, the size of the array is only recognized > > as 74G, rather than the true 148G. I've double-checked all my BIOS > > settings, and nothing seems out of order. Please help! -- greg byshenk - [EMAIL PROTECTED] - Leiden, NL _______________________________________________ freebsd-stable@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-stable To unsubscribe, send any mail to "[EMAIL PROTECTED]"
