Sebastian Ahndorf wrote:
Kris Kennaway wrote:
Both sides must have same config, autosense should work if there is
no config possibility in other end.
autosense may in fact not work, especially on low-quality NICs like rl.
I don't agree to that.
I had similar problems with my network using a cheap switch with some
realtek nics. I had the nics running 100baseTX Full Duplex.
Changing this to autosense made the problems gone.
I would second that. My cheap rl card performs better with auto than
with either 100TX-full or 100TX-half ('tho its always auto'ed to 100TX
full duplex anyway).
And by way of interest, I have just experienced a similar problem with
NICs + 100 baseT switch - it was a 3Com Office connect card (xl driver)
that I had the issues with, and ended up replacing it with a DLink (vr
driver).
Cheers
Mark
_______________________________________________
freebsd-stable@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-stable
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
