> > I am preparing a new server for production use.
> > It contains 2 1000BaseTX NICs and 2 SCSI controllers.
> > The interrupt assignment performed by ACPI looks kinda strange:
> > irq24: bge0 ahd0
> > irq25: bge1 ahd1
> > How can I affect it? I mean I want all the devices use different IRQ lines.
>
> What hardware, curiously? Are all of these parts onboard? Can you post
> the ouptut of 'devconf'? This will show the bus associations for these
> devices.
Its Tyan S2882 and all the devices are onboard ones.
I dont know about devconf ($ locate devconf produces empty output as well)
but pciconf results are as follows:
[EMAIL PROTECTED]:6:0: class=0x010000 card=0x005e9005 chip=0x801d9005 rev=0x10
hdr=0x00
vendor = 'Adaptec Inc'
device = 'AIC-7902B Ultra320 SCSI Controller'
class = mass storage
subclass = SCSI
[EMAIL PROTECTED]:6:1: class=0x010000 card=0x005e9005 chip=0x801d9005 rev=0x10
hdr=0x00
vendor = 'Adaptec Inc'
device = 'AIC-7902B Ultra320 SCSI Controller'
class = mass storage
subclass = SCSI
[EMAIL PROTECTED]:9:0: class=0x020000 card=0x164414e4 chip=0x164814e4 rev=0x03
hdr=0x00
vendor = 'Broadcom Corporation'
device = 'BCM5704 NetXtreme Dual Gigabit Adapter'
class = network
subclass = ethernet
[EMAIL PROTECTED]:9:1: class=0x020000 card=0x164414e4 chip=0x164814e4 rev=0x03
hdr=0x00
vendor = 'Broadcom Corporation'
device = 'BCM5704 NetXtreme Dual Gigabit Adapter'
class = network
subclass = ethernet
The server runs i386 version of FreeBSD (5.3-RELEASE-p5) since
I experienced some problems building ports on amd64 version.
> In many cases there are not other IRQs available to route, due to poor
> BIOS programming, ccorners cut in the physical board layout, etc.
I think this is the case :/
The BIOS assigned all those devices IRQ10 and there is no way to change the
settings...
_______________________________________________
freebsd-stable@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-stable
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
