As in powers off? How bigs the PSU? Lawrence Farr EPC Direct Limited
> -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED]] On Behalf Of Morsal Roudbay > Sent: 29 November 2001 10:45 > To: Kristian K. Nielsen > Cc: [EMAIL PROTECTED] > Subject: Re: 4.4-STABLE crashes - suspects new ata-driver > over wd-driver > > > I seem to have the same problem... when my IDE drive is under > heavy use the > whole computer goes down. :( It's my server so it's very > serious. My root > partition is a SCSI drive.. the IDE drive is only used for > ports... and the > computer often shuts down when I run the command "portsdb > -uU"... (heavy > disk usage) > > > On Sat, Oct 13, 2001 at 03:06:56PM +0200, Kristian K. Nielsen wrote: > > Hey, > > > > Motherboard hardware: ASUS P2B with ASUS latest BIOS update 1012 > > > > Recently I upgraded my good FreeBSD server from 3.5-STABLE > to 4.4-STABLE and > > after > > that the kernel has constantly being panicing. > > Before upgrading I never have had unexpected kernel panics > - now the box > > goes down > > with a day. > > I suspects the new ata-driver since the panics seem to > happened when there > > is most disk > > activity like seeks or copying lots of data from one place > to another. > > > > The panic could look like this - here stangely in an > inactive RealServer > > (but seem to happen in any running process not nesserily > the one causing the > > diskactivity): > > > > IdlePTD 3276800 > > initial pcb at 2966c0 > > panicstr: page fault > > panic messages: > > --- > > Fatal trap 12: page fault while in kernel mode > > fault virtual address = 0x7145cfb0 > > fault code = supervisor read, page not present > > instruction pointer = 0x8:0xc01496d2 > > stack pointer = 0x10:0xd720ef20 > > frame pointer = 0x10:0xd720ef38 > > code segment = base 0x0, limit 0xfffff, type 0x1b > > = DPL 0, pres 1, def32 1, gran 1 > > processor eflags = interrupt enabled, resume, IOPL = 0 > > current process = 364 (rmserver) > > interrupt mask = none > > trap number = 12 > > panic: page fault > > > > syncing disks... 104 13 10 9 8 > > done > > Uptime: 18h53m51s > > > > -------- > > > > dmesg returns: > > Copyright (c) 1992-2001 The FreeBSD Project. > > Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, > 1992, 1993, 1994 > > The Regents of the University of California. All > rights reserved. > > FreeBSD 4.4-STABLE #0: Wed Oct 10 23:33:25 CEST 2001 > > [EMAIL PROTECTED]:/usr/src/sys/compile/JKKN_KRNL > > Timecounter "i8254" frequency 1193182 Hz > > Timecounter "TSC" frequency 300683475 Hz > > CPU: Pentium II/Pentium II Xeon/Celeron (300.68-MHz 686-class CPU) > > Origin = "GenuineIntel" Id = 0x634 Stepping = 4 > > > > > Features=0x80f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR, > PGE,MCA,CMOV,M > > MX> > > real memory = 402640896 (393204K bytes) > > avail memory = 387919872 (378828K bytes) > > Preloaded elf kernel "kernel" at 0xc0301000. > > Pentium Pro MTRR support enabled > > Using $PIR table, 6 entries at 0xc00f0d10 > > npx0: <math processor> on motherboard > > npx0: INT 16 interface > > pcib0: <Intel 82443BX (440 BX) host to PCI bridge> on motherboard > > pci0: <PCI bus> on pcib0 > > pcib1: <Intel 82443BX (440 BX) PCI-PCI (AGP) bridge> at > device 1.0 on pci0 > > pci1: <PCI bus> on pcib1 > > isab0: <Intel 82371AB PCI to ISA bridge> at device 4.0 on pci0 > > isa0: <ISA bus> on isab0 > > atapci0: <Intel PIIX4 ATA33 controller> port 0xd800-0xd80f > at device 4.1 on > > pci0 > > ata0: at 0x1f0 irq 14 on atapci0 > > ata1: at 0x170 irq 15 on atapci0 > > pci0: <Intel 82371AB/EB (PIIX4) USB controller> at 4.2 > > chip1: <Intel 82371AB Power management controller> port > 0xe800-0xe80f at > > device 4.3 on pci0 > > rl0: <RealTek 8139 10/100BaseTX> port 0xd000-0xd0ff mem > > 0xe3000000-0xe30000ff irq 10 at device 10.0 on pci0 > > rl0: Ethernet address: 00:40:95:30:2e:5e > > miibus0: <MII bus> on rl0 > > rlphy0: <RealTek internal media interface> on miibus0 > > rlphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto > > pci0: <S3 ViRGE DX/GX graphics accelerator> at 12.0 irq 11 > > orm0: <Option ROM> at iomem 0xc0000-0xc7fff on isa0 > > fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 > drq 2 on isa0 > > fdc0: FIFO enabled, 8 bytes threshold > > fd0: <1440-KB 3.5" drive> on fdc0 drive 0 > > atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0 > > vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem > 0xa0000-0xbffff on isa0 > > sc0: <System console> at flags 0x100 on isa0 > > sc0: VGA <16 virtual consoles, flags=0x300> > > sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0 > > sio0: type 16550A > > sio1 at port 0x2f8-0x2ff irq 3 on isa0 > > sio1: type 16550A > > ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0 > > ppc0: SMC-like chipset (ECP/EPP/PS2/NIBBLE) in COMPATIBLE mode > > ppc0: FIFO with 16/16/9 bytes threshold > > lpt0: <Printer> on ppbus0 > > lpt0: Interrupt-driven port > > ppi0: <Parallel I/O> on ppbus0 > > IPsec: Initialized Security Association Processing. > > ad0: 8207MB <ST38641A> [16676/16/63] at ata0-master UDMA33 > > ad2: 9641MB <IBM-DTTA-371010> [19590/16/63] at ata1-master UDMA33 > > acd0: CD-RW <CD-RW CRX100E> at ata1-slave using PIO4 > > Mounting root from ufs:/dev/ad0s1a > > > > > > ----- > > > > > > (kgdb) where > > #0 dumpsys () at ../../kern/kern_shutdown.c:473 > > #1 0xc0143efc in boot (howto=256) at ../../kern/kern_shutdown.c:313 > > #2 0xc01442dc in poweroff_wait (junk=0xc02711ac, howto=-1071182641) > > at ../../kern/kern_shutdown.c:581 > > #3 0xc023b07f in trap_fatal (frame=0xd720eee0, eva=1900400560) > > at ../../i386/i386/trap.c:956 > > #4 0xc023ad39 in trap_pfault (frame=0xd720eee0, > usermode=0, eva=1900400560) > > at ../../i386/i386/trap.c:849 > > #5 0xc023a90f in trap (frame={tf_fs = 16, tf_es = -685768688, tf_ds > > = -685768688, > > tf_edi = 753273225, tf_esi = 1900400556, tf_ebp = -685707464, > > tf_isp = -685707508, tf_ebx = 4, tf_edx = -685707516, > tf_ecx = 59999, > > tf_eax = 4, tf_trapno = 12, tf_err = 0, tf_eip = > -1072392494, tf_cs = > > 8, > > tf_eflags = 66066, tf_esp = -755888352, tf_ss = 2}) > > at ../../i386/i386/trap.c:448 > > #6 0xc01496d2 in nanosleep (p=0xd2f20f20, uap=0xd720ef80) > > at ../../kern/kern_time.c:283 > > #7 0xc023b2e1 in syscall2 (frame={tf_fs = 47, tf_es = 47, tf_ds > > = -1078001617, > > tf_edi = 0, tf_esi = 60000, tf_ebp = -1077937184, > tf_isp = -685707308, > > tf_ebx = 673886912, tf_edx = -1, tf_ecx = 4, tf_eax = > 240, tf_trapno = > > 22, > > tf_err = 2, tf_eip = 673632288, tf_cs = 31, tf_eflags = 659, > > tf_esp = -1077937220, tf_ss = 47}) at > ../../i386/i386/trap.c:1155 > > #8 0xc022f8a5 in Xint0x80_syscall () > > #9 0x8074fd6 in ?? () > > #10 0x8075302 in ?? () > > #11 0x80728cd in ?? () > > #12 0x8076d8b in ?? () > > ---Type <return> to continue, or q <return> to quit--- > > #13 0x804fa3d in ?? () > > #14 0x804eb7d in ?? () > > > > > > ----- > > > > > > For more information - please contact me at [EMAIL PROTECTED] > > > > > > I apreciate any help, > > > > Kristian K. Nielsen > > > > > > > > To Unsubscribe: send mail to [EMAIL PROTECTED] > with "unsubscribe freebsd-stable" in the body of the message > To Unsubscribe: send mail to [EMAIL PROTECTED] with "unsubscribe freebsd-stable" in the body of the message
