On Sun, 1 Oct 2000, Rodney W. Grimes wrote:
> >
> > Something is wrong with your system, check cabling, cooling and memory.
>
> I would change that to check, in order, cooling, cpu voltage setting,
> memory and memory timing, power supply, and finally cabling.
>
> If you have one of the rare 2.4V 450MHz K6-2-450 they are extreamly
I have this one. It worked fine with Vcore 2.2V for couple of months, then
started giving strange signal in buildworld. I was going nuts since the
temperature was normal and was almost sure it's RAM that went bad.
Decreasing Vcore to 2.1 made it panic soon after boot but increasing to
2.4 made it work ok.
It's getting warmer though, so like the people say - be sure about
heat sink and heat sink grease.
--Roman Shterenzon, UNIX System Administrator and Consultant
[ Xpert UNIX Systems Ltd., Herzlia, Israel. Tel: +972-9-9522361 ]
To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-stable" in the body of the message
