On Thu, Dec 19, 2019 at 2:53 PM Eugene Grosbein <eu...@grosbein.net> wrote: > You either switch the controller to "HBA" mode using its setup utility, > or keep it in current "RAID" mode but configure your SSD as "Non-RAID" drive.
Tried HBA mode. Devices attached as AHCI were not recognized. Tried leaving in RAID mode: cannot have two non_RAID devices. Its either one (Raid) and one (non-Raid) or one RAID only. Only one VD_ defined mirror pair in RAID mode was recognized after boot by the ISO boot media. Is it possible interrupting second stage boot to set hw.x.y.z=<val> sysctl type settings would help? Something about device recognition? > > Also, you must use mrsas(4) driver instead of default mfi(4) to get TRIM > support for SSD. > mfi(4) has no TRIM support at all. You may switch to mrsas(4) after > intallation, though. Thanks for the tip! -G _______________________________________________ freebsd-stable@freebsd.org mailing list https://lists.freebsd.org/mailman/listinfo/freebsd-stable To unsubscribe, send any mail to "freebsd-stable-unsubscr...@freebsd.org"
