Hi,
I've got HP ProLiant DL320g5p server with HP Smart Array E200 RAID
controller and 4X300Gb SAS disks.
I'd like to use it for hosting jails on ZFS, but no matter how I create
zpool, I always get a warning about non-native block size:
block size: 8192B configured, 1048576B native
I know it is optimal for ZFS to have direct access to disks, but HP
Smart Array E200 apparently does not support JBOD mode. I tried to
configure both single RAID-5 logical volume and four RAID-0
logical volumes, in both cases diskinfo gives me the following:
512 # sectorsize
299966445568 # mediasize in bytes (279G)
585871964 # mediasize in sectors
1048576 # stripesize
643072 # stripeoffset
71798 # Cylinders according to firmware.
255 # Heads according to firmware.
32 # Sectors according to firmware.
PA6C90R9SXK07P # Disk ident.
With hardware I have, is it better to create single RAID-5 logical
volume in HP Smart Array E200 and let ZFS think it deals with single
physical drive, or four RAID-0 logical volumes and let ZFS think it
deals with four physical drives?
Can I just ignore warning about non-native block size? If not, how can
I make it go away?
Thank you in advance,
--
Before enlightenment - chop wood, draw water.
After enlightenment - chop wood, draw water.
Marko Cupać
https://www.mimar.rs/
_______________________________________________
freebsd-stable@freebsd.org mailing list
https://lists.freebsd.org/mailman/listinfo/freebsd-stable
To unsubscribe, send any mail to "freebsd-stable-unsubscr...@freebsd.org"
