On Tue, 12 Feb 2013, Daniel Braniss wrote: > > On Tue, 12 Feb 2013, Daniel Braniss wrote: > > > > > I finally got a 10G card that is recognized by FreeBSD (9.1-stable): > > > ... > > > ix0: <Intel(R) PRO/10GbE PCI-Express Network Driver, Version - 2.4.8> port > > > 0xecc0-0xecdf mem 0xd9e80000-0xd9efffff,0xd9ff8000-0xd9ffbfff irq 40 at > > > d=evice > > > 0.0 on pci4 > > > ix0: Using MSIX interrupts with 9 vectors > > > ix0: RX Descriptors exceed system mbuf max, using default instead! > > > > From reading sys/dev/ixgbe/README: > > > > echo "kern.ipc.nmbclusters=262144" >> /etc/sysctl.conf > > echo "kern.ipc.nmbjumbop=262144" >> /etc/sysctl.conf > > reboot > > but this only works if the driver is loaded after > the sysctl is executed! > it's better to put it in /boot/loader.conf
Not necessarily, it depends when the driver grabs the mbufs. In the case of the igb/ixgb/ixgbe drivers, this happens when the interface is brought up (not when the driver is loaded, nor when the driver probes/attaches a PHY). In other words, you don't have to worry about mbuf exhaustion until you say "ifconfig ix0 up" (in the case of ixgbe, bringing up even a single interface is enough through the default mbufs and require more). Since sysctl.conf is processed before the network is brought up, putting the parameters in sysctl.conf will be perfectly suitable for most needs (unless for some strange reason you need to "up" an interface before sysctl.conf is processed). -- Devin _____________ The information contained in this message is proprietary and/or confidential. If you are not the intended recipient, please: (i) delete the message and all copies; (ii) do not disclose, distribute or use the message in any manner; and (iii) notify the sender immediately. In addition, please be aware that any message addressed to our domain is subject to archiving and review by persons other than the intended recipient. Thank you. _______________________________________________ freebsd-stable@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-stable To unsubscribe, send any mail to "freebsd-stable-unsubscr...@freebsd.org"
