Steven Hartland <kill...@multiplay.co.uk> wrote:
>----- Original Message -----
>From: "Andriy Gapon" <a...@freebsd.org>
>
>
>> on 11/01/2013 21:38 Willem Jan Withagen said the following:
>>> On 2013-01-07 18:06, Julian Stecklina wrote:
>>>> Has this been resolved? I still see a hang on reboot/shutdown on my
>box
>>>> (zfs root on USB thumb drive), but I am not sure if the problem is
>>>> related.
>>>
>>> Could very well be be.
>>>
>>> I have again the same problem as I reported before with the full and
>new
>>> 9.1 code.
>>> But did not have time yet to build a system te test with.
>>>
>>> My other 9.1 box is my ZFS only fileserver. And I do not want to
>fidle
>>> to much with it.
>
>Not sure if this has been suggested or ruled out as yet but if you have
>usb
>enabled, you don't need to be using it, try the following see if it
>helps?
>
>sysctl hw.usb.no_shutdown_wait=1
With that sysctl set the box shuts down just fine. Thanks!
>
>If it does
>1. Temporary fix is to pop that in /etc/sysctl.conf
>2. Worth investigating which USB component isn't dropping references
>correctly.
I only have an USB thumb drive and a USB soundcard attached. I tried it without
the soundcard attached and would still not reset/shutdown, so that does not
seem to be the problem.
I attached usbconfig list output.
Julian
--
Sent from Kaiten Mail. Please excuse my brevity.
ugen0.1: <OHCI root HUB ATI> at usbus0, cfg=0 md=HOST spd=FULL (12Mbps) pwr=SAVE
ugen1.1: <EHCI root HUB ATI> at usbus1, cfg=0 md=HOST spd=HIGH (480Mbps)
pwr=SAVE
ugen2.1: <OHCI root HUB ATI> at usbus2, cfg=0 md=HOST spd=FULL (12Mbps) pwr=SAVE
ugen3.1: <EHCI root HUB ATI> at usbus3, cfg=0 md=HOST spd=HIGH (480Mbps)
pwr=SAVE
ugen4.1: <OHCI root HUB ATI> at usbus4, cfg=0 md=HOST spd=FULL (12Mbps) pwr=SAVE
ugen5.1: <EHCI root HUB ATI> at usbus5, cfg=0 md=HOST spd=HIGH (480Mbps)
pwr=SAVE
ugen2.2: <USB Audio CODEC Burr-Brown from TI> at usbus2, cfg=0 md=HOST spd=FULL
(12Mbps) pwr=ON
ugen3.2: <Cruzer Switch SanDisk> at usbus3, cfg=0 md=HOST spd=HIGH (480Mbps)
pwr=ON
_______________________________________________
freebsd-stable@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-stable
To unsubscribe, send any mail to "freebsd-stable-unsubscr...@freebsd.org"
