Daniel O'Connor wrote:
On 15/05/2011, at 24:36, Thomas Krause wrote:
I'm not sure with /boot/devices.hint. Could you give me a hint, how to
set
# camcontrol devlist
<AMCC 9500S-4LP DISK 2.08> at scbus0 target 0 lun 0 (da0,pass0)
<Samsung G3 Station> at scbus1 target 0 lun 0 (pass1,da1)
the Samsung G3 permanently to da1 (the AMCC must be da0).
(This is a productive system and I don't want to do tests ...)
I think the following will work..
hint.scbus.0.at="twa0"
hint.da.0.at="scbus1"
hint.scbus.1.at="umass-sim0"
hint.da.1.at="scbus0"
Unfortunately I can't check the system I tested this on at the moment.
I would strongly suggest you use glabel& UFS IDs (or GPT IDs if you used GPT
when installing) in fstab rather than wiring device nodes.
--
Daniel O'Connor software and network engineer
for Genesis Software - http://www.gsoft.com.au
"The nice thing about standards is that there
are so many of them to choose from."
-- Andrew Tanenbaum
GPG Fingerprint - 5596 B766 97C0 0E94 4347 295E E593 DC20 7B3F CE8C
_______________________________________________
freebsd-stable@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-stable
To unsubscribe, send any mail to "freebsd-stable-unsubscr...@freebsd.org"
I think I have an answer to your problem. "man glabel".
Backup all data first!
glabel label -v usr /dev/da1
newfs /dev/label/usr
mount /dev/label/usr /usr
[...]
umount /usr
glabel stop usr
glabel unload
I got that unload is unavailable but it everything worked for me. Check
the man page. Hope this helps.
Bruce
_______________________________________________
freebsd-stable@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-stable
To unsubscribe, send any mail to "freebsd-stable-unsubscr...@freebsd.org"
