Greetings everyone. I'm trying to install FreeBSD 8.0 from Disk1 on
ThinkPad T40, so far unsuccessfully.
Here are the setup steps:
Installer complains that "77520/16/63" may not be a good geometry for
ad0, proposes "4864/255/63" instead (both eventually lead to failure).
I create a single disk-wide slice (ad0s1), choose a boot manager, set up
standard labeling for ad0s1, choose distributions.
The setup tries to create filesystem and fails with this message:
Unable to find device node for /dev/ad0s1b in /dev!
Aside from debug messages, there's this on second VT:
GEOM: ad0: geometry does not match label (255h,63s != 16h,63s).
I also tried to setup 7.0 (w/o dangerously dedicated slicing), and then
freebsd-update to 8.0. On first reboot required by freebsd-update the
system drops to bootloader prompt and fails to find init on any of the
filesystems.
Help. Is there anything I can do to install 8.0?
The dmesg of this machine (as seen by 7.0) is at [1]. I'll provide any
further information -- just name it.
[1] http://tx97.net/~magv/dmesg-t40.70.txt
_______________________________________________
freebsd-stable@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-stable
To unsubscribe, send any mail to "freebsd-stable-unsubscr...@freebsd.org"
