Hi,
I recently upgraded to -stable (from 3.2) to use some of the fixes to
a variety of things like aio_* and some thread stuff. However, I
appear to have botched something else entirely: my HP SCSI tape drive
does not work.
It is found (here's some dmesg output):
sa0 at ahc0 bus 0 target 3 lun 0
sa0: <HP C1537A L708> Removable Sequential Access SCSI-2 device
sa0: 10.000MB/s transfers (10.000MHz, offset 32)
The major and minor numbers are correct (and I did a MAKEDEV). But,
if I try to just check on things:
$ mt stat
mt: /dev/nrsa0: Device not configured
Anyone have any ideas? Does this ring any bells? What on earth did I
do wrong? I can't imagine that this would matter, but my scsi card is
ultra-2, and I have an ultra-2 to wide adapter on it for the tape
drive.
Thanks a lot. A week of no backups is beginning to wig me out.
Soren
To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-stable" in the body of the message
