Dialin modem has been working very well, with the exception of a couple times last night when I couldn't connect. Here's the mgetty logs. Note these lines:
01/16 02:10:35 yd0 waiting for ``CONNECT'' ** found **
01/16 02:10:56 yd0 send:
01/16 02:10:56 yd0 waiting for ``_'' ** found **
01/16 02:11:00 yd0 clean_line: only 500 of 10000 bytes logged
01/16 02:11:00 yd0 clean_line: got too much junk (dev=ttyd0).: No such file or directory
01/16 02:11:01 ##### failed dev=ttyd0, pid=7942, got signal 3, exiting
[the complete mgetty log is at the end]
There are also some PPP errors:
Jan 16 02:33:23 freebsd ppp[8044]: tun0: Command: default: add default HISADDR
Jan 16 02:33:23 freebsd ppp[8044]: tun0: Warning: Add route failed: 0.0.0.0/0 already exists
Jan 16 02:33:23 freebsd ppp[8044]: tun0: Command: pap: enable pap
Jan 16 02:33:23 freebsd ppp[8044]: tun0: Command: pap: set ifaddr 192.168.1.3 192.168.1.4-192.168.1.9
here is my ppp.conf... do I need to change the 'set ifaddr' line?
default:
set device /dev/cuaa0
set log Phase Chat LCP IPCP CCP tun command
enable passwdauth
set speed 115200
set dial "ABORT BUSY ABORT NO\\sCARRIER TIMEOUT 5 \"\" AT OK-AT-OK ATE1Q0 OK \\dATDT\\TTIMEOUT 40 CONNECT"
set timeout 120
set ifaddr 192.168.1.1/0 192.168.1.2/0 255.255.255.0 0.0.0.0
add default HISADDR
cuaa0: set ifaddr 192.168.1.3 192.168.1.4-192.168.1.9 enable passwdauth allow users ppp accept dns set dns 67.36.13.26 66.73.20.40 enable proxy
pap: enable pap set ifaddr 192.168.1.3 192.168.1.4-192.168.1.9 enable proxy enable passwdauth
here's another ppp.log snippet that seems to indicate a problem with passwdauth, as pppd shouldn't look for etc/ppp/ppp.secret unless passwdauth is NOT set:
Jan 16 02:33:26 freebsd ppp[8044]: tun0: Phase: bundle: Authenticate
Jan 16 02:33:26 freebsd ppp[8044]: tun0: Phase: deflink: his = none, mine = PAP
Jan 16 02:33:26 freebsd ppp[8044]: tun0: LCP: deflink: RecvEchoRequest(0) state = Opened
Jan 16 02:33:26 freebsd ppp[8044]: tun0: LCP: deflink: SendEchoReply(0) state = Opened
Jan 16 02:33:26 freebsd ppp[8044]: tun0: Phase: Pap Input: REQUEST (ppp)
Jan 16 02:33:26 freebsd ppp[8044]: tun0: Warning: OpenSecret: Can't open /etc/ppp/ppp.secret.
Jan 16 02:33:26 freebsd ppp[8044]: tun0: Phase: Pap Output: SUCCESS
Jan 16 02:33:26 freebsd ppp[8044]: tun0: Warning: OpenSecret: Can't open /etc/ppp/ppp.secret.
Jan 16 02:33:26 freebsd ppp[8044]: tun0: CCP: FSM: Using "deflink" as a transport
Jan 16 02:33:26 freebsd ppp[8044]: tun0: CCP: deflink: State change Initial --> Closed
Jan 16 02:33:26 freebsd ppp[8044]: tun0: CCP: deflink: LayerStart.
Jan 16 02:33:26 freebsd ppp[8044]: tun0: CCP: MPPE: Not usable without CHAP81
Jan 16 02:33:26 freebsd ppp[8044]: tun0: CCP: deflink: SendConfigReq(1) state = Closed
Jan 16 02:33:26 freebsd ppp[8044]: tun0: CCP: DEFLATE[4] win 15
Jan 16 02:33:26 freebsd ppp[8044]: tun0: CCP: PRED1[2]
Jan 16 02:33:26 freebsd ppp[8044]: tun0: CCP: deflink: State change Closed --> Req-Sent
Jan 16 02:33:26 freebsd ppp[8044]: tun0: Phase: deflink: lcp -> open
later on:
Jan 16 02:34:56 freebsd ppp[8082]: tun0: IPCP: myaddr 192.168.1.3 hisaddr = 192.168.1.5
Jan 16 02:34:56 freebsd ppp[8082]: tun0: Warning: ff02:5::/32: Change route failed: errno: Network is unreachable
Jan 16 02:34:56 freebsd ppp[8082]: tun0: LCP: deflink: RecvProtocolRej(223) state = Opened
Jan 16 02:34:56 freebsd ppp[8082]: tun0: LCP: deflink: -- Protocol 0x8057 (Internet Protocol V6 Control Protocol) was rejected!
Jan 16 02:34:56 freebsd ppp[8082]: tun0: Phase: deflink: IPV6CP protocol reject closes IPV6CP !
Jan 16 02:34:56 freebsd ppp[8082]: tun0: IPCP: deflink: RecvConfigReq(4) state = Opened
Jan 16 02:34:56 freebsd ppp[8082]: tun0: IPCP: deflink: LayerDown: 192.168.1.3
Jan 16 02:34:56 freebsd ppp[8082]: tun0: IPCP: COMPPROTO[6] 16 VJ slots with slot compression
Jan 16 02:34:56 freebsd ppp[8082]: tun0: IPCP: IPADDR[6] 192.168.1.5
I don't want to flood the list with log snippets, so I'll stop, but will send more if someone thinks it would be beneficial.
Again, the symptoms here are either not getting connected at all on dial in, or getting connected but not being able to get anywhere (even by IP address).
[here's the complete mgetty log]
01/16 01:51:49 yd0 mgetty: experimental test release 1.1.31-Jul24
01/16 01:51:49 yd0 check for lockfiles
01/16 01:51:49 yd0 locking the line
01/16 01:51:49 yd0 lowering DTR to reset Modem
01/16 01:51:50 yd0 send: \dATQ0V1H0[0d]
01/16 01:51:50 yd0 waiting for ``OK'' ** found **
01/16 01:51:51 yd0 send: ATS0=0Q0&D3&C1[0d]
01/16 01:51:51 yd0 waiting for ``OK'' ** found **
01/16 01:51:51 yd0 mdm_send: 'ATI'
01/16 01:51:51 yd0 Generic Rockwell modem (56000)
01/16 01:51:51 yd0 mdm_send: 'ATI3'
01/16 01:51:51 yd0 mdm_send: 'ATI4'
01/16 01:51:51 yd0 additional info: 'a007040284C6002F'
01/16 01:51:51 yd0 modem quirks: 0004
01/16 01:51:51 yd0 mdm_send: 'AT+FCLASS=2' -> OK
01/16 01:51:51 yd0 mdm_send: 'AT+FCLASS=0' -> OK
01/16 01:51:51 yd0 mdm_send: 'AT+FAA=1;+FCR=1' -> OK
01/16 01:51:51 yd0 mdm_send: 'AT+FBOR=0' -> OK
01/16 01:51:51 yd0 mdm_send: 'AT+FLID="49 115 xxxxxxxx"' -> OK
01/16 01:51:51 yd0 mdm_send: 'AT+FDCC=1,5,0,2,0,0,0,0' -> OK
01/16 01:51:51 yd0 waiting...
01/16 02:10:35 yd0 wfr: waiting for ``RING''
01/16 02:10:35 yd0 send: ATA[0d]
01/16 02:10:35 yd0 waiting for ``CONNECT'' ** found **
01/16 02:10:56 yd0 send:
01/16 02:10:56 yd0 waiting for ``_'' ** found **
01/16 02:11:00 yd0 clean_line: only 500 of 10000 bytes logged
01/16 02:11:00 yd0 clean_line: got too much junk (dev=ttyd0).: No such file or directory
01/16 02:11:01 ##### failed dev=ttyd0, pid=7942, got signal 3, exiting
_______________________________________________ freebsd-questions@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"
