On Wed, 24 Nov 2004 05:18:08 -0600, Nikolas Britton
<[EMAIL PROTECTED]> wrote:
> Gerard Seibert wrote:
>
> >I am going to do a fresh install of FreBSD 5.3 this weekend on my
> >computer. Immediately after the installation I want to do a
> >buildworld and install a custom kernel.
> >
> >My question is what special arguments should I use in the 'make.conf'
> >file for this project. Is it really necessary to change this file at
> >all? I was reading the handbook and it mentioned the 'CFLAGGS' entry
> >and a few others.
> >
> >
> I'd recommend leaving CFLAGS and COPTFLAGS alone (I've only managed to
> make problems when I set these),
Well, that, of course, is a matter of opinion. If you want the most
optimization possible, you could try using "-O2" or even "-O3". I've
been using "-O3" quite successfully here lately, with the exception of a
couple of ports which required changing it to "-O2".
I believe the "-pipe" switch is on by default (as well as "-O", but if
not, it does help to speed up builds a bit as well.
> but I would change CPUTYPE to your
> CPU Type, options are:
>
> AMD CPU: athlon-mp, athlon-xp, athlon-4, athlon-tbird, athlon, k6-3,
> k6-2, k6, k5
And don't forget athlon64! In fact, I initially setup my amd64 box by
installing from an i386 CD set I had here, then cross-compiling the
world and kernel using "-march=athlon64 -m64".
> Intel CPU: p4, p3, p2, i686, i586/mmx, i586, i486, i386
>
> If you want to rebuild a custom kernel add this:
> KERNCONF=FOOBAR
And copy /usr/src/sys/${ARCH}/conf/GENERIC to
/usr/src/sys/${ARCH}/conf/FOOBAR and edit to taste, where ${ARCH} equals
your machine architecture (i386, amd64, etc.).
> --------------------------------------------------------------
> For your kernel config file comment out everything you don't need
> (make sure you have a "working" kernel b4 you buildworld), i.g:
>
> cpu I486_CPU
> cpu I586_CPU
> device eisa
> device atapifd # ATAPI floppy drives
> device atapist # ATAPI tape drives
> all the SCSI Controllers
> etc.
> Don't forget to add in sound support etc. etc.
>
> ---------------------------------------------------------------
> then buildworld:
> # cvsup -g -L 2 foobar-supfile (set the cvs release tag to RELENG_5_3)
> # cd /usr/src
> # make -j2 buildworld && make -j2 buildkernel && make -j2
> Installkernel && reboot
> test your new kernel, if it works drop down to single user mode
> # shutdown now
> # cd /usr/src
> # make installworld
> # reboot
> If system is still working then mergemaster
> # mergemaster
> # reboot
> Done.
>
> rm -r /usr/obj/*
>
> >I would welcome any feedback that is available.
> >
> >Thanks!
--
Conrad J. Sabatier <[EMAIL PROTECTED]> -- "In Unix veritas"
_______________________________________________
[EMAIL PROTECTED] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
