Howdy foilks,
I have a SCSI controller (the external 68-pin high density connector on
a Compaq Proliant 1600) that seems to ignore it's own settings when I
through its bus speed down. This is a problem, as I'm running into
/many/ SCSI bus reset problems with this ancient DEC 7-bay JBOD tower
that I'm playing with. The problems go away when I use
`camcontrol negotiate -R 10 da0` to drop the bus freq to 10MHz from
20MHz and I'd hope to simply set the controller to that speed. No love,
sigh. FreeBSD comes up at the drives are 20MHz:
da0: 40.000MB/s transfers (20.000MHz, offset 15, 16bit), Tagged Queueing Enabled
I'd like to find a way to have camcontrol (or some other mechanism) set
the SCSI bus speed on this particular SCSI chain early in the boot
process, /before/ it encounters fsck and thus trips over it's own feet
in bus resets. If it matters, the SCSI controller shows in dmesg as:
sym1: <875> port 0x3400-0x34ff mem 0xc6efe000-0xc6efefff,0xc6efde00-0xc6efdeff
irq 10 at device 9.1 on pci1
sym1: No NVRAM, ID 7, Fast-20, SE, parity checking
sym1: [GIANT-LOCKED]
Any pointers?
-T
--
Keeping UUCP running is starting to seem a lot like keeping a 130-year-
old man who smokes 4 packs a day on life support because he's the last
person on Earth who knows how to do the cha-cha, but he won't tell anyone.
- A.S.R. quote (Ryan Tucker)
_______________________________________________
[EMAIL PROTECTED] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
