On Sat, 10 Jul 2004 19:39:06 -0500, Jason Dusek <[EMAIL PROTECTED]> wrote: > Hi, > > I have a Dell D600, and I count mount flash devices on it. They show up in > dmesg. Here I put the drive in the top one, pull it out and stick it in the > bottom one, and then put it back in the top one: > > ugen0: SanDisk Corporation Cruzer Mini, rev 2.00/0.10, addr 2 > ugen0: at uhub0 port 1 (addr 2) disconnected > ugen0: detached > ugen0: SanDisk Corporation Cruzer Mini, rev 2.00/0.10, addr 2 > ugen0: at uhub0 port 1 (addr 2) disconnected > ugen0: detached > ugen0: SanDisk Corporation Cruzer Mini, rev 2.00/0.10, addr 2 > > Strangely, they show up as the same address on the same device. When I try to > mount ugen0, I get a message that sayeth: > > Block device required. > > What does this mean? What do I do?
Hi Jason, Check out this page which is a great walk through on getting what you need set up: http://ezine.daemonnews.org/200305/cfmount.html In particular, you need to mount the corresponding 'da' device, not the ugen device. --roop _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"
