> -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of > Lowell Gilbert > Sent: Thursday, July 08, 2004 2:17 PM > To: [EMAIL PROTECTED] > Cc: [EMAIL PROTECTED] > Subject: Re: Network configuration > > > "Terrence Koeman" <[EMAIL PROTECTED]> writes: > > > Hi, > > > > I have been busy setting up a network the last 3 days, but I cannot > > get it working. > > > > Basically I have no clue what has to be setup etc. and if I need > > bridging or not. > > > > The situation is as follows: > > > > -------------- > > | SDSL Modem | > > | Bridged | > > -------------- > > | > > -------------------------- > > | xl0: 217.1.1.155 | > > | | > > | Freebsd Box | > > | | > > | xl1 | > > -------------------------- > > | > > ---------- > > |---------------| SWITCH |---------------| > > | ---------- | > > | | | > > ------------------- ------------------- ------------------- > > | C1: 217.1.1.156 | | C2: 217.1.1.157 | | C3: 217.1.1.158 | > > ------------------- ------------------- -------------------
One thing I noticed is that there isn't an IP address assigned to xl1. This needs to be done, afaik. If you're out of IP addresses, NAT is going to be your thing, on a third interface perhaps. Here's what I'm getting at: As an example, set the IP address of xl1 to 217.1.1.154. Then, set up the routing table on the freebsd box so that all outgoing packets get passed to xl0, and any packet destined for 156, 157, or 158 get passed back to xl1. Set the default gateway on your machines to .154. This should have you up and running. If this doesn't make sense to you, send me an email and I'll try to explain further. HTH Eric Crist _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"
