On Sun, Jun 20, 2004 at 12:45:57PM +1000, Jason Oakley wrote:
> I set up automount, but that's not working.
>
> usb1: <VIA 83C572 USB controller> on uhci1
> usb1: USB revision 1.0
> uhub1: VIA UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
> uhub1: 2 ports with 2 removable, self powered
>
>
> I also get this after a reboot now:
> umass0: vendor 0x55aa 8-in-2, rev 1.10/1.01, addr 3
[...]
That's weird. I assume from your other message that you did get all of the
slots working by the magic of 'camcontrol rescan', but it all went horribly
wrong when you tweaked usbd.conf or set up the automounter?
Does everything still work if you undo whatever changes you did (keep a
copy of the changed files though), reboot and try to mount the CF card
again? If it does, could you put your changes back, reboot again and then
post copies of your /var/log/dmesg.boot, /etc/rc.conf, /etc/usbd.conf and
/etc/amd.map files? Output from 'usbdevs -v' and 'camcontrol devlist'
might be useful too.
Something I should have mentioned before - you probably want to do
'camcontrol eject 0:0:whatever' after unmounting a card, to power down the
slot before pulling it out. There's a small chance of damaging the card if
you don't do this.
Cheers,
Scott
--
===========================================================================
Scott Mitchell | PGP Key ID | "Eagles may soar, but weasels
Cambridge, England | 0x54B171B9 | don't get sucked into jet engines"
scott at fishballoon.org | 0xAA775B8B | -- Anon
_______________________________________________
[EMAIL PROTECTED] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
