thank you On Sat, 5 Jun 2004, Eric Crist wrote:
> You need to kill all the running dhclient processes, then try again. > Usually, this can be done with: > > #killall -9 dhclient > > HTH > > Eric F Crist > President > AdTech Integrated Systems, Inc > (612) 998-3588 > > > > > -----Original Message----- > > From: [EMAIL PROTECTED] > > [mailto:[EMAIL PROTECTED] On Behalf Of > > [EMAIL PROTECTED] > > Sent: Saturday, June 05, 2004 11:29 AM > > To: [EMAIL PROTECTED] > > Subject: routing question > > > > > > I am trying to configure a wireless router so I am redefining > > routes and IP address of my system. After booting dhclient > > ep0 works fine. After messing around with the wireless router > > I was just going back to my ethernet connection so I did: > > > > ifconfig ep0 192.168.0.3 remove > > arp -da > > route flush > > dhclient ep0 > > > > This returned immediatly without assigning an IP or route so > > I just connected manually using ifconfig and route. There > > must be something I did not clear out, but I can not figure > > it out. Thanks for any ideas. This is on 4.10 if that makes > > any difference. > > > > _____ > > Douglas Denault > > http://www.safeport.com > > [EMAIL PROTECTED] > > Voice: 301-469-8766 > > Fax: 301-469-0601 _______________________________________________ > > [EMAIL PROTECTED] mailing list > > http://lists.freebsd.org/mailman/listinfo/free> bsd-questions > > > > To unsubscribe, send any mail to > > "[EMAIL PROTECTED]" > > > > _____ Douglas Denault http://www.safeport.com [EMAIL PROTECTED] Voice: 301-469-8766 Fax: 301-469-0601 _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"
