I dont understand this...
Here is what I see:
I have an adaptec 29160 controller..
sa0 at ahc0 bus 0 target 3 lun 0
sa0: <HP C1533A A907> Removable Sequential Access SCSI-2 device
sa0: 10.000MB/s transfers (10.000MHz, offset 32)
da0 at ahc0 bus 0 target 0 lun 0
da0: <QUANTUM ATLAS10K3_18_WLS 020W> Fixed Direct Access SCSI-3 device
da0: 40.000MB/s transfers (20.000MHz, offset 127, 16bit), Tagged Queueing Enabled
da0: 17537MB (35916548 512 byte sectors: 255H 63S/T 2235C)
It 'sees' both the drive and the tape unit...
However, doing 'mt status' gives me this: # mt status mt: /dev/nsa0: Device not configured
yet the dev looks ok:
lrwxr-xr-x 1 root wheel 4 Apr 4 20:18 nsa0 -> nsa0.0 crw-rw---- 1 root operator 14, 1 Apr 4 20:18 nsa0.0 crw-rw---- 1 root operator 14, 5 Apr 4 20:18 nsa0.1 crw-rw---- 1 root operator 14, 9 Apr 4 20:18 nsa0.2 crw-rw---- 1 root operator 14, 13 Apr 4 20:18 nsa0.3
What am I missing here?
The tape drive works fine on my other *bsd machines...and FreeBSD does see this unit...
Help?
Sorry - Someone (not me!) ejected the tape.....
(oops)
** DISCLAIMER **
Per Anti-Virus Policy, this e-email has been scanned for viruses.
Scanned clean by F-PROT ANTIVIRUS 4.4.1 - http://www.f-prot.com
_______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"
