RYAN vAN GINNEKEN wrote:
I run FreeBSD 4.9 and keep getting this message in my dmesg both the
cable and the drive are cable of UDMA 100 at least and the board is a
newer Intel 865 chip set. Do i have to configure something in my kernel
or what??
ad0: DMA limited to UDMA33, non-ATA66 cable or device
ad0: 38204MB <SAMSUNG SP0411N> [77622/16/63] at ata0-master UDMA33
acd0: CD-RW <HL-DT-ST GCE-8525B> at ata1-master PIO4
Mounting root from ufs:/dev/ad0s1a
We were talking about this very thing not too long ago on this list.
Some have claimed this can happen if you:
a] Plug the cable in backwards - ie., the end with the single plug
should go into the motherboard and the end that has the two plugs
closer together should go into the drives.
b] Plug the wrong one of the two that are closer together into the
driver.
So I'd say try pulling out the cable and plugging it back in in a
different way.
Another thing to be sure of is that you have the UDMA 100 cable;
ie, one end should have a blue connector and that end should go into
the motherboard.
--
Jonathan Arnold (mailto:[EMAIL PROTECTED])
Daemon Dancing in the Dark, a FreeBSD weblog:
http://freebsd.amazingdev.com/blog/
_______________________________________________
[EMAIL PROTECTED] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
