Re: Multiple RealTect adaptors

[Mykroft Holmes IV]

Peter Rosa wrote:

Hello again,

of course, everything was there:
dmesg - YES
ifconfig - YES
rc.conf - YES
But, whenever the machine boots, ifconfig returns:
rl0: flags 8843 <snip> mtu 1500
    inet 192.168.1.11 netmask <snip>
    ether <snip>
    media <snip>
    status: active
rl1: flags 8843 <snip> mtu 1500
    ether <snip>
    media <snip>
    status: no carrier
Both have the same flags. Second has no IP/MSK/BCAST.

ifconfig rl1  192.168.1.12 netmask 255.255.255.0 always returns
config: ioctl (SIOCIFADDR): File exists
What could be wrong ?

It is the same when I xchange both cards/use another PCI slots.

Peter

 

Try putting the second NIC on a second subnet. IIRC FreeBSD doesn't 
support multiple adaptors on the same network.

Adam

_______________________________________________
[EMAIL PROTECTED] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"