On Sun, Sep 28, 2003 at 07:41:04AM -0400, nw1 wrote: > Neither mouse will work in the console or in XFree86. > > Gigabyte GA-6BXDS = main board > BIOS= AWARD (2A69KG01) ver. 4.51PG > > In the PCI/ISA section of the BIOS, a USB setting of: "Assign IRQ For USB: Enabled" > (is > set) > There is also a "USB Keyboard Support" setting within the BIOS's "INTERGRATED > PEROPHERALS" section; I have tried this setting to both "Enabled and Disabled". > > There aren't any other USB settings in this BIOS. > > We are using these devices that are known working devices. > Mouse-1 is: Logitech | model: M-BD58 | optical corded wheel > Mouse-2 is: Logitech | model: M-RM67A | Optical cordless wheel
The models doesn't tell me much. I have a optical cordless wheel mouse from logitech and this work fine here. The USB plugin should work but I didn't try it here. I did try USB on a mouse much like you type 1. > Our Kernel: > # USB support > device uhci # UHCI PCI->USB interface > device usb # USB Bus (required) > device ums # Mouse > pseudo-device ether # Ethernet support Instead of using your own kernel, try using the GENERIC kernel instead for the test. > > Our /etc/rc.conf: > # grep -i mouse /etc/rc.conf > moused_enable="YES" > moused_port="/dev/ums0" You could try to add this: moused_type="auto" (you may have to specify the type for USB) > # grep -i usb /etc/rc.conf > usbd_enable="YES" > > Our /dev: > ls -l /dev | grep -i ums > crw-rw---- 1 root operator 111, 0 Sep 27 13:16 ums0 > > dmesg reports: > # dmesg | grep -i usb > uhci0: <Intel 82371AB/EB (PIIX4) USB controller> port 0xa000-0xa01f irq 10 at device > 7.2 > on pci0 > usb0: <Intel 82371AB/EB (PIIX4) USB controller> on uhci0 > usb0: USB revision 1.0 > ums0: Logitech USB Mouse, rev 1.10/6.10, addr 2, iclass 3/1 > > Upon booting into the OS, using the above BIOS, and other settings --with either of > the > above devices; the mouse is seen on screen, but it refuse to respond while moving the > hand-held device. Should we unplug one mouse (from either usb port) to test the > other > mouse, we receive the following on-screen message(s), respectively of the > motherboards USB > port we were using: > > uhub0: device problem, disabling port 2 > uhub0: device problem, disabling port 1 > > When we plug the devices back in to either of the motherboards mouse ports, there's > no > indication at all, from the OS, that a USB device was attached. > > Reminder: these devices are in perfect working order. I can't give you a comment on this. It look ok. -- Alex Articles based on solutions that I use: http://www.kruijff.org/alex/index.php?dir=docs/FreeBSD/ _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"
