check out this page:
http://www.freebsd.org/doc/en_US.ISO8859-1/books/handbook/install-steps.htmlBefore you install and configure FreeBSD on your system, there is an important subject that you should be aware of, especially if you have multiple hard drives.
In a PC running a BIOS-dependent operating system such as MS-DOS or Microsoft Windows, the BIOS is able to abstract the normal disk drive order, and the operating system goes along with the change. This allows the user to boot from a disk drive other than the so-called ``primary master''.
A user who is accustomed to taking advantage of these features may become surprised when the results with FreeBSD are not as expected. FreeBSD does not use the BIOS, and does not know the ``logical BIOS drive mapping''. This can lead to very perplexing situations, especially when drives are physically identical in geometry, and have also been made as data clones of one another.
When using FreeBSD, always restore the BIOS to natural drive numbering before installing FreeBSD, and then leave it that way. If you need to switch drives around, then do so, but do it the hard way, and open the case and move the jumpers and cables.
hope this helps, Chris
At 05:26 PM 5/28/2003 -0500, you wrote:
I have an old IBM PC320 Server with the following hardware (use to have Microsoft SBS 4.5 installed before I tried to install FreeBSD):
128MB RAM 2 (4.5GB) Quantum Viking WSE SCSI hard drives, one is SCSI ID#0 and the other SCSI ID#1 SCSI ID#7 Adaptec AHA-2940 SCSI controller SCSI ID#2 HP 35470A Tape Drive SCSI ID#3 IBM CDRM00203 SCSI CD-ROM Trident TGVA (1MB) video card 2 (100Mhz) Pentium Processors
Installed FreeBSD 4.8 (and also tried FreeBSD 4.2) with no hiccups using the outlined installation in the FreeBSD handbook with no other operating systems. When I go to reboot, the Boot Manager comes up with two options: F1 FreeBSD and F5 Drive 1 (or F5 Drive 0, depending if I select F5). Neither work. It will not boot past this point. What am I doing wrong? I know it probably has something to do with my SCSI ID's but I don't have a clue what arrangement or BIOS settings that need to be adjusted. Has anyone installed on this type of server and if so, what settings are needed on the physical server. Or is there a way to get around it in the installation process. Thanks for all your help! I'd really like to get FreeBSD going on this particular box.
David Nicholas [EMAIL PROTECTED]
_______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-newbies To unsubscribe, send any mail to "[EMAIL PROTECTED]"
/**************************************
Chris Gillis
Network/Systems Administrator,
Webmaster,
all around computer guy :)
Neuroscience @ FSU
office: 850-644-4876
fax: 850-644-0989
**************************************/
_______________________________________________
[EMAIL PROTECTED] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
