On Tue, May 1, 2012 at 8:06 AM, Anton Shterenlikht <[email protected]> wrote: > I run 10-current on Compaq 6715s. > It's very hot and noisy. If I boot > in verbose mode, I get lots of: > > acpi_tz0: _AC2: temperature 92.0 >= setpoint 50.0 > acpi_tz0: _AC1: temperature 92.0 >= setpoint 60.0 > acpi_tz0: _AC3: temperature 92.0 >= setpoint 40.0 > acpi_tz0: _AC2: temperature 92.0 >= setpoint 50.0 > acpi_tz0: _AC1: temperature 92.0 >= setpoint 60.0 > > at the console. > > I guess it's telling me that the CPU is too hot? > > Is that normal, e.g. under "make -j4 buildworld"? >
Probably not. I had a laptop with similar symptom when I was compiling stuff. I took it apart, cleaned it and thought that maybe these log messages were normal under stress. The CPU eventually fried and only then I took a real close look and the heatsink had a very tiny little hole where the fluid escaped, but it was not at all apparent at first sight. These liquid (or gel?) filled heatsinks are basically useless if the liquid escapes or evaporates so it will usually only show when you are using the CPU a lot. -- Alejandro Imass > Thanks > > -- > Anton Shterenlikht > Room 2.6, Queen's Building > Mech Eng Dept > Bristol University > University Walk, Bristol BS8 1TR, UK > Tel: +44 (0)117 331 5944 > Fax: +44 (0)117 929 4423 > _______________________________________________ > [email protected] mailing list > http://lists.freebsd.org/mailman/listinfo/freebsd-questions > To unsubscribe, send any mail to "[email protected]" _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[email protected]"
