Op 1-8-2011 16:37, Dan Nelson schreef:
In the last episode (Aug 01), Dick Hoogendijk said:
OK, my freebsd system runs on ZFS boot. W/ solaris getting larger disks
for a pool was quit easy. Simply replace one disk from a mirror for a
larger one, wait for the resilvering and after this replace the second
one for a larger disk and wait for the resilvering again. That's it.
Been there, done that. But my feeling tells me it is not that simple for
a FreeBSD zfs root system, or is it?
Should be the same procedure. Make sure you either use "zpool online -e"
when swapping in the new disks, or that you have the zpool autoexpand=on
attribute set.
But I'm confused about the gpart thing I did on the original disks.
$ gpart show
=> 34 156301421 ad4 GPT (75G)
34 128 1 freebsd-boot (64K)
162 8388608 2 freebsd-swap (4.0G)
8388770 147912685 3 freebsd-zfs (71G)
=> 34 156301421 ad6 GPT (75G)
34 128 1 freebsd-boot (64K)
162 8388608 2 freebsd-swap (4.0G)
8388770 147912685 3 freebsd-zfs (71G)
Do I repeat this gpart section on the new disk(s) before putting them in
the rpool (one at a time). Is it compatrible to putting the solaris
bootcode on disk before attaching them to a rootpool and resilvering? I
want to expand my rootpool but am a little confused about the right
procedure.
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "freebsd-questions-unsubscr...@freebsd.org"
