vi(1) motion commands "]]" and "[[" move to
beginning of next or previous section respectively.
Using vi(1) ":set sect" command I can verify
that a section in my case is set to:
sections="NHSHH HUnhsh"
Why then on a *.tex file the above motion
commands move to "{" in the first column?
For example, in this file:
1 It is possible to show using linear algebra that Tresca cylinder has
2 a hexagon as a base, and von Mises condition has a circle. Because
3 neither is dependent on the volumetric stress, it is convenient to
4 plot stress states on 2D plane normal to $\sigma_{kk}=0$ plane,
5 {\em deviatoric plane}, see Fig. \ref{fig:plane}
6
7 \begin{figure}[htb]
8 \centerline{\includegraphics[width=6cm]{./figs/yield_plane.pdf}}
9 \caption{Tresca hexagon and von Mises circle on the deviatoric plane.}
10 \label{fig:plane}
11 \end{figure}
12
vi "[[" or "]]" move to line 5.
Many thanks
--
Anton Shterenlikht
Room 2.6, Queen's Building
Mech Eng Dept
Bristol University
University Walk, Bristol BS8 1TR, UK
Tel: +44 (0)117 331 5944
Fax: +44 (0)117 929 4423
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "freebsd-questions-unsubscr...@freebsd.org"
