I'd appreciate it if someone could lend some assistance with this issue. The machine in question is pretty much unusable atm!
Regards, Casey ----- "Casey Scott" <[email protected]> wrote: > Since upgrading to 8.0 RELEASE, I continually get these errors: > > ... > Jun 11 15:24:08 xxxx kernel: ad6: 953869MB <Seagate ST31000340AS SD1A> > at ata3-master SATA150 > Jun 11 15:24:08 xxxx kernel: (probe6:ahc0:0:6:0): TEST UNIT READY. > CDB: 0 0 0 0 0 0 > Jun 11 15:24:08 xxxx kernel: (probe6:ahc0:0:6:0): CAM Status: SCSI > Status Error > Jun 11 15:24:08 xxxx kernel: (probe6:ahc0:0:6:0): SCSI Status: Check > Condition > Jun 11 15:24:08 xxxx kernel: (probe6:ahc0:0:6:0): UNIT ATTENTION > asc:29,2 > Jun 11 15:24:08 xxxx kernel: (probe6:ahc0:0:6:0): SCSI bus reset > occurred > Jun 11 15:24:08 xxxx kernel: (probe6:ahc0:0:6:0): Retrying Command > (per Sense Data) > ... > > > I've tried 3 different drives w/ 2 different disk controllers. > Anything I use as the second drive generates this message on boot, and > will eventually fail with timeout errors after a couple hours. The > other drive on the system, ad4, never displays these symptoms. This > isn't new hardware, and worked flawlessly until now. > > Any suggestions? Has a bug been introduced into the ata driver? > > Regards, > Casey > _______________________________________________ > [email protected] mailing list > http://lists.freebsd.org/mailman/listinfo/freebsd-questions > To unsubscribe, send any mail to > "[email protected]" _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[email protected]"
