On 03/10/10 15:56, Leslie Jensen wrote:
I'm trying to install FreeBSD 8-RELEASE on a machine with an Abit
aw8-max MB. This MB has a built in SiI 3132 RAID controller. I also
have an addon card with a SiI 3124 RAID controller.
The problem is that I can see the 2 disks and the RAID1 set that I
want to use for the system if I connect the disks to the built in 3132
controller. But if I connect the disks to the 3124 controller and
create a RAID1 set, only the disks can be seen.
I need to be able to use both controllers because I've got four disks
that I want to build a RAID5 set on one of the controllers.
Can anyone shed some light on this. Via Google I've read some articles
about these controllers and I'm aware that I might have to rethink
because of lacking support for the 3124 controller.
I've read in the ata man page that parameters can be added to
/boot/device.hints but I'm not sure how to handle this during
installation.
/Leslie
Are you using the default ata(4) driver that FreeBSD-8 boots with, or
are you loading the siis(4) module at boot? If you are using the ata(4)
driver, you should try enabling the siis(4) driver by placing
'siis_load="YES"' in /boot/loader.conf. Beware that the names of your
disks will transition from ad -> ada and will likely be renumbered as well.
The siis(4) driver overall has a much richer feature set. I have
several 3124 controllers which work great with it, but I have never
tried using the controllers RAID - I simply use them as disk controllers
and then pool the disks using ZFS.
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[email protected]"
