On Tue, 1 Dec 2009, Anton Shterenlikht wrote:
On Tue, Dec 01, 2009 at 05:27:11PM +0100, Gheorghe Ardelean wrote:
Hello Anton ... to FreeBSD sparc64,
I get to OK prompt, type "boot cdrom", but the process
stops after a few seconds with:
jumping to kernel entry at 0xc0088000.
I think supported system means that it is working at least via serial
console (this is the case e.g for Plain Ultra 1).
So when I see something like this I hook-up a serial console and try over
it.
ok, 8.0 installation went fine.
On reboot I get this panic (typed by hand):
Entropy harvesting: interrupts ethernet point_to_pointpanic: trap:
memory
address not aligned
Automatic reboot in 15 seconds
Any advice?
Maybe marius@ can help you.
But I would also give 7.2 a try. 7.2-RELEASE was the first release to
support Blade 1500 IIRC.
Regards,
Gheorghe Ardelean.
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[email protected]"
