Hi all, I'm trying to get my CD drive to work without so much success. Reading is fine, but when I try to burn a CD I get errors in dmesg.
Using cdrecord -blank=fast dev=3,0,0 I get: [...] Using generic SCSI-3/mmc CD-ROM driver (mmc_cd). Driver flags : MMC-3 SWABAUDIO BURNFREE Supported modes: TAO PACKET SAO SAO/R96P SAO/R96R RAW/R16 RAW/R96P RAW/R96R Starting to write CD/DVD at speed 18 in real BLANK mode for single session. Last chance to quit, starting real write 0 seconds. Operation starts. This drive or media does not support the 'BLANK media' command cdrecord: Cannot blank disk, aborting. cdrecord: Some drives do not support all blank types. cdrecord: Try again with cdrecord blank=all. And dmesg shows: acd0: FAILURE - READ_BUFFER ILLEGAL REQUEST asc=0x24 ascq=0x00 acd0: FAILURE - MODE_SELECT_BIG ILLEGAL REQUEST asc=0x26 ascq=0x00 Using burncd blank I get: burncd: ioctl(CDRIOCBLANK): Input/output error and in dmesg: acd0: FAILURE - BLANK_CMD ILLEGAL REQUEST asc=0x30 ascq=0x05 The drive works perfectly with other OS, so I don't think the hardware is the problem. The device is identified as: acd0: DVDR <TSSTcorp CDDVDW TS-H653N/0208> at ata3-master SATA150 I have scbus, atapicd and atapicam in my kernel configuration. Any ideas? Thanks in advance. _______________________________________________ freebsd-questions@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "freebsd-questions-unsubscr...@freebsd.org"
