Greets!
I have a Dell Poweredge 2300/350 machine that I'm trying to
install 5.0-RELEASE on via the CD. I'm getting an unusual error that my
searches have revealed very little on (seems to be a problem a lot of
laptop users get, although this is a 6U server).
Server setup is as follows:
Dual 350Mhz 512MB RAM
RAID5 via Perc SC/2 (does detect successfully)
Booting off RELEASE ISO CD
I boot, kernel starts to detect hardware and then these are the last few
lines I get before the machine hangs (hard...have to use reset switch.
Can't even get a light change from hitting "num lock" anymore)
atapci0: <Intel PIIX4ATA33 controller> port 0xffa0-0xffaf at device 7.1
on pci0
atapci0: Busmastering DMA not supported
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
uhci0: <Intel 72371AB/EB (PIIX4) USB controller> port 0-0x1f at device
7.2 on pci0
pci_cfgintr: 0:7 INTD routed to irq 14
And that's it. I've never run into anything quite like this...
Thoughts?
John Straiton
[EMAIL PROTECTED]
Clickcom, Inc
704-365-9970x101
To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-questions" in the body of the message
