I received the same error with both make and gmake.
Thanks,
Jay
On Thu, May 1, 2008 at 8:30 AM, Lowell Gilbert wrote:
Jay Hall <[EMAIL PROTECTED]> writes:
I am attempting to compile Perl 5.8.8 on FreeBSD 7.0-RELEASE. I make
it through the configuration just fine, but when I attempt to run the
make command, I receive the following error message. I am creating a
custom install. The only parameter I am changing is the installation
location.
make: don't know how to make <command-line>. Stop.
I have run make depend, and it finishes without any problems.
I'm sure this is something simple I am missing because I have been
looking at the problem for so long.
Thanks in advance for your assistance.
Even for non-standard location installs, I recommend using the ports
instead of building yourself, but if you really want to do it by hand,
expect to need to know a bit more about what you're doing. In this
case, I suspect you need to use gmake instead of (the native) make.
--
Lowell Gilbert, embedded/networking software engineer, Boston area
http://be-well.ilk.org/~lowell/
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
