answer but there is one thing that is still a puzzle.
I have a pipe configured as:
ipfw pipe 2 config bw 768Kbit/s queue 20Kbytes
When I use `ipfw -s 4 pipe 2 show, one bucket is shown:
00002: 768.000 Kbit/s 0 ms 20 KB 1 queues (1 buckets) droptail
mask: 0x00 0x00000000/0x0000 -> 0x00000000/0x0000
BKT Prot ___Source IP/port____ ____Dest. IP/port____ Tot_pkt/bytes Pkt/Byte Drp
0 tcp 12.###.##.77/80 88.###.##.175/2200 10565 8421549 0 0 103
I understand that there is only one bucket but how are the source and
destination ip addresses and ports chosen to be displayed from all that are
yes. use queues through this pipe for implementing smart traffic control
(best of a kind i must say).
While I'm at it this pipe has a 768 Kbps bw limit and is currently running at
what kind of traffic is it? single or lots of tcp connections? looks like
a single connection
less than 250 Kbps. Why are packets still being dropped at the rate of about
1%, fairly consistently?
turn off the pipe and check the traffic again. it looks like your pipe is
setup correctly.
are other rules ok?
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
