Mike Meyer wrote: > In <[EMAIL PROTECTED]>, David Larkin <[EMAIL PROTECTED]> typed: > > I was wondering if any subscibers to this list recognise the > > following problem. > > > > I just purchased 2 identical machines and I am looking to install 4.7 > > from CD. > [...] > > It then formats the hard disk ok, but reports > > > > acd0: TEST_UNIT_READY command timeout - resetting > > ata1: resetting devices .. done > > ( The message repeats itself many times.) > > > > finally it gives up and gives error message > > > > Error mounting /dev/acd0c on dist Input/Output Error(5) > > > > Any ideas why it should boot from CD, but not then recognise it ? > > I'm taking a shot in the dark, but is the CD on the secondary > controller as a slave, and there's no master on that controller? That > configuration causes problems for FreeBSD. I'm not sure it would cause > the timeouts you are seeing, but it does cause FreeBSD to fail to > recognize drives. >
Wasn't that , but thanks for the tip ;-) Changed CDROM now all ok. > > <mike > -- > Mike Meyer <[EMAIL PROTECTED]> http://www.mired.org/consulting.html > Independent WWW/Perforce/FreeBSD/Unix consultant, email for more information. To Unsubscribe: send mail to [EMAIL PROTECTED] with "unsubscribe freebsd-questions" in the body of the message
