On Mon, Nov 27, 2006 at 07:48:44PM +0200, Dima wrote: Well, this is something I have not seen, so I hope someone else can weigh in on it.
////jerry > > On Mon, Nov 27, 2006 at 06:58:32PM +0200, Dima wrote: > > > Hmmm. I am presuming you are booted from an install CD. > Yes, I'm booting from install CD. > > >> By the way there are some error messages regarding this on Ctrl+Alt+F2 > >> (during install), but they say nothing to me: > >> ad0: WARNING - READ_DMA UDMA ICRC error (retrying request) LBA=0 > >> ad0: WARNING - READ_DMA UDMA ICRC error (retrying request) LBA=0 > >> ad0: FAILURE - READ_DMA status=51<READY,DSC,ERROR> > >> error=84<ICRC,ABORTED> > >> LBA=0 > >> They're repeated 4 times. > > > > Hmmm. > > I don't remember seeing anything like those when I had the afore-mentioned > > problem. That looks like something is connected wrong or being addressed > > wrong. It isn't a geometry issue, I don't think. > > But Red Hat 9 still works fine on that hardware. What can be wrong? > > >> My HDD is Master on first IDE-channel, CD-ROM - Secondary on the same > >> channel. > > > > Can you find the dmesg information for both the disk and the CD reader > > during the boot? Are they producing device identifiers and specs that > > look correct? > > Those lines will start with 'adnn:' and 'acdnn:' where nn is a number, > > probably '0' (you hope). > > Yes, I can: > ad0: 238457 MB <WDC WD2500JB-00GVC0 08.02D08> at ata0-master UDMA > acd0 ..... at ata0-slave looks fine too (I'm too lazy to copy it :) > Also I have ad2 and it seems fine on dmesg too. > After that goes > > ad0: WARNING - READ_DMA UDMA ICRC error (retrying request) LBA=0 > ad0: WARNING - READ_DMA UDMA ICRC error (retrying request) LBA=0 > ad0: FAILURE - READ_DMA status=51<READY,DSC,ERROR> > > and repeats 3 times. > > _______________________________________________ freebsd-questions@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"
