On Sep 15, 2006, at 12:28 PM, [EMAIL PROTECTED] wrote:
I'm beginning the install of 6.1 RELEASE on a Dell 1950. It uses
Dual Embedded Broadcom NetXtreme II 5708 Gigabit Ethernet NICs, and
they are not correctly recognized during the install. The system
identifies them as bce0 and bce1, but apparently the driver isn't
working right.
Does anyone have these NICs working? If so, what driver did you use?
Paul Schmehl ([EMAIL PROTECTED])
Adjunct Information Security Officer
The University of Texas at Dallas
http://www.utdallas.edu/ir/security/
Those particular cards should use a generic driver (in this case bc).
The fact that your interfaces are found though seems to point to the
fact that things are not configured properly, network-wise. Are you
sure the network settings you're providing are correct, or that the
actual NICs themselves have a solid link to a switch and are working?
-Garrett
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
