On 17-May-06, at 12:05 PM, Howard Jones wrote:
Jason Lixfeld wrote:
Well, I managed to sort it out. The grey area was that the Dell
BMC just needed an IP, username and password configured on it. I
was under the mistaken impression that the OpenIPMI needed to be
installed to speak the BMC, but ipmitools does that just fine.
Between the BMC and megarc for the raid status, I have everything
I need! Well, with the exception of SNMP traps -- still haven't
figured out how to set the trap host and community, but if worst
comes to worst, I can use used net-snmp and use the exec options
in snmpd.conf.
Where does this IP address present itself? On an SC1425 we have
here, I can set an IP etc in the BMC BIOS, but it lists a MAC
address there that isn't the same as either of the GigE interfaces
on the mobo.
Is it overlaid in some strange way, or do I need some sort of
daughterboard? I'd like to get this going for all our Dells if I can.
The MAC address on the BMC is different on my 1850s as well. You
don't need any daughterboard, it just runs off the onboard NIC and
you can even hit it when the power is off on the machine (slick!!).
You don't need to configure or compile anything in userland on the
system at all, just install ipmitool and you're off to the races:
From what I understand, you can't do anything to the IP on the BMC
except hit it with something like ipmitool:
# ipmitool -I lan -H 192.168.100.100 -U root channel info
Password:
Channel 0x1 info:
Channel Medium Type : 802.3 LAN
Channel Protocol Type : IPMB-1.0
Session Support : session-based
Active Session Count : 1
Protocol Vendor ID : 7154
Volatile(active) Settings
Alerting : disabled
Per-message Auth : disabled
User Level Auth : enabled
Access Mode : always available
Non-Volatile Settings
Alerting : disabled
Per-message Auth : disabled
User Level Auth : enabled
Access Mode : always available
#
Cheers,
Howie
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
