yes, but cable is disabled at the moment
I think there is a problem with DS/1Mbps
this driver seems to allow by default the transfer rate: 1 Mbps
my wlan access point accept only 54Mbps !
I think I must change to 54Mbps using ifconfig
Do you know, howto change this ?
# ifconfig ath0 media DS/54Mbps
ifconfig: unknown media subtype: DS/54Mbps
--- On Mon 08/08, Andrew L. Gould < [EMAIL PROTECTED] > wrote:
From: Andrew L. Gould [mailto: [EMAIL PROTECTED]
To: [EMAIL PROTECTED]
Cc: freebsd-questions@freebsd.org
Date: Mon, 8 Aug 2005 16:07:11 -0500
Subject: Re: howto load or install wlan_wep module on freeBSD 5.4 ?
On Mon, 8 Aug 2005 16:57:44 -0400 (EDT)<br>"PK" <[EMAIL PROTECTED]>
wrote:<br><br>> <br>> 1. Poor signal strength<br>> <br>> no, very good (1 meter
distance)<br>> windows installed on the same machine shows 100% <br>> <br>> 2.
Improperly configured nameserver information (/etc/resolv.conf)<br>> <br>> it's
correct, because with ethernet nic works well<br>> <br>> 3. Improperly
configured default gateway<br>> <br>> it's correct, otherwise I cannot ping the
default router from<br>> the ethernet nic<br>> <br>> other question<br>> <br>>
howto set (change) DS/1Mbps to 54Mbps ? <br>> <br>> <br><br>Do you have your
cable and wireless interfaces configured to the same<br>network?<br><br>Andrew
Gould<br>
_______________________________________________
Join Excite! - http://www.excite.com
The most personalized portal on the Web!
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
