Hi, I have a gvinum setup and am using an adaptec 7899 controller. Upon removing a drive (testing gvinum), the following happens... Is this message useful at all without a backtrace? Is there interest in getting a proper backtrace? I am running FreeBSD 5.4-RELEASE on a dell poweredge 1550 using one of its two cpus.
GEOM_VINUM: subdisk usr.p0.s1 state change: up-> down GEOM_VINUM: plex usr.p0.state change: up->degraded GEOM_VINUM: subdisk home.p0.s1 state change: up->down GEOM_VINUM: plex home.p0.s1 state change up->degraded writing vhdr failed: 6(da1:ahc0:0:1:0): synchronize cache failed, status 0x5b, scsi status = 0x0 (da1:ahc0:1:0): removing device entry gvinum: lost drive 'middle' fatal trap 12: page fault while in kernel mode fault virtual address = 0x18c fault code = supervisor write, page not present instruction pointer = 0x8:0xc00449654 stack pointer = 0x10:0xe5537bf0 frame pointer = 0x10:0xe5537bf0 cs = base 0x0 limit 0xfffff, type 0x1b DPL = 0, pres 1, def32 1, gran 1 processor eflags = interrupt enabled, resume, IPOL=0 current process = 38 (irq27:ahc0) trap number = 12 panic: page fault uptime 9m20s ahc0: spurious SCSI interrupt. Thanks, Andrew _______________________________________________ freebsd-questions@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"
