On Thu, 2005-06-09 at 02:42 -0400, Allyn Cheney wrote: > I'm trying to setup a Freebsd box to act as my router/firewall and as such > I've been trying to configure it to connect to my ISP's PPPoE dsl service. It > doesn't connect and the errors provided in the log prove don't show me much > content as to what is causing the problem. One thing strange is ppp is saying > its using tun1, while below you can see its saying its using tun0 and > erroring. Error log, ppp.conf and rc.conf are listed below. > > Error log: > ppp[198]: tun0: Phase: deflink: Connected! > ppp[198]: tun0: Phase: deflink: opening -> dial > ppp[198]: tun0: Phase: deflink: dial -> carrier > ppp[198]: tun0: Phase: deflink: Disconnected! > ppp[198]: tun0: Phase: deflink: Connect Time: 5 sec > ppp[198]: tun0: Phase: deflink: hangup - > opening > > ppp.conf > default: > set log Phase chat lcp ipcp ccp tun command > set if addr 10.10.0.1/0 10.10.0.2/0 > set mtu 1492 > set mru 1492 > set device PPPoE:rl0 > > papchap: > set authname name > set authkey key > set dial > set login > add default HISADDR > > rc.conf > ppp_enable="YES" > ppp_mode="ddial" > ppp_nat="YES" > ppp_profile="papchap" > gateway_enabled="YES" > ifconfig_rl0="DHCP" > ifconfig_dc0="inet 10.10.0.1 netmask 255.255.255.248" > hostname="name"
I would suggest leaving out ifaddr.. It's not required. Also, it looks like you have your PPPoE device wrong by the rc.conf values you listed. Here's what works for me: default: set device PPPoE:fxp0 set speed sync set ctsrts off set mru 1492 set mtu 1492 provider: set authname "name" set authkey "key" enable dns # this will enable pulling the dns from your provider and sticking them in /etc/resolv.conf add default HISADDR To dial with that I run 'ppp -ddial provider'. Hope it helps. Tim _______________________________________________ freebsd-questions@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"
